How soon after a storm should water damage be looked at?
Within hours if you can see or smell water inside. Wet insulation and wet board start degrading immediately, and in a humid climate the conditions for mold growth are present quickly. Waiting for a roofer to be available is not a reason to leave the inside wet, because they are separate jobs.
After a widespread storm, every trade in the area is busy at once, and the common outcome is a building that waits a week for a roof and spends that week wet. The drying work does not have to wait for the permanent repair, and temporary weather protection plus drying is usually the cheaper order of events.
Can a storm cause water damage with no visible roof damage?
Yes, and it is common. Wind-driven rain enters at window heads, siding laps, vents and wall penetrations that shed ordinary rain without trouble. The roof can be intact while the top of a wall is wet. That is why a technician looks at the weather side of the building, not only upward.
The mechanism is pressure as much as water. Wind pushes against a wall and finds any path through a lap or a joint, and once water is inside the cladding it runs down the back of it to whatever stops it. The stain inside appears at that stopping point, which may be a floor below the entry.
Is storm water treated as clean water?
Not usually. Rain reaching a building through a damaged roof or wall picks up debris, dust and whatever is in the cavity it passes through, and runoff across ground and paving is further from clean. Materials are treated according to what the water carried, which is assessed on site rather than assumed.
A ceiling soaked by rain that came straight through a fresh opening may be handled as relatively clean. The same water after it has run through an attic full of old insulation and dust is not the same water by the time it reaches a bedroom. That difference decides what is dried and what is removed.
What affects what a storm damage job costs here?
How many entry points there are, how far the water traveled inside, how much insulation and board must come out, whether access needs height or scaffold, the age and construction of the building, and how long drying takes in humid conditions. The scope is explained and approved before work begins.
No price figures for this trade are sourced locally, so this site publishes none, not even national ones. The scope you are asked to approve names the entry points, the materials coming out, the equipment going in and the expected drying period. The storm roof leak guide explains the same ground in plain words.
Who repairs the roof or window after the drying is done?
A licensed contractor in the relevant trade. Water damage restoration dries the building and removes what cannot be saved; it is not roofing or glazing. In AL, the Alabama Home Builders Licensure Board requires a state homebuilder license on residential jobs over $10,000 and a separate roofer license for storm-roof replacement over $2,500.
That split catches people out after a storm, because the obvious problem is the hole and the urgent problem is the water. Sequencing them properly means temporary protection, then drying, then the permanent repair into a dry structure. Repairing into wet framing is how a stain comes back without new rain.